PRODUCT INFORMATION

AND INSTRUCTIONS  

Each container comes with a closed cap, threaded cap with opening and a threaded 'needle' spout.

​

1. SureStik liquid adhesive is made to be applied to your glass WITHOUT lifting glass pieces in your design.

          When you have completed your entire project, tilt the applicator bottle with the needle spout giving it a slight squeeze so that a drop of SureStik comes in contact with the edge of the design element that you are sticking to your base glass. The liquid will run under the design piece adhering the two pieces together. Allow about 15 minutes for SureStik to set with 1/2 hour to dry completely. The slower setting time allows you to adjust your design if necessary.

​

2. SureStik C and all design elements used in fusing. When adhering stringers, drop some liquid onto each end to ensure they don't roll when firing. Use needle spout.

​

3. SureStik can be mixed with powder or fine frit to make a paste for designing. It can also be mixed with larger frit for easier placement of the pieces ensuring they will not move. Use threaded cap.

​

4. SureStik will completely burn off in the kiln leaving a clean surface to your glass. It is water soluble - change your mind?- wash your design with water and start again or drop some more SureStik liquid to move your design around.

 

     4 OZ = $12.00                              16 OZ = $25.00

​