ASSEMBLY INSTRUCTIONS
Each container comes with a closed cap, a threaded
cap with opening and a pink threaded 'needle' spout.
CLOSED CAP
Replace the closed cap with the threaded cap with
opening for applying adhesive for general application.
REGULAR OPENING
Thread the pink 'needle' spout to the threaded
cap with a one turn twist for precise application.
NEEDLE SPOUT
Adhesive can be stored with any cap
INSTRUCTIONS FOR USE
SureStik™ liquid adhesive is made to be applied to your glass WITHOUT lifting glass pieces in your design.
When you have completed your entire project, tilt the applicator bottle with a slight squeeze so that a drop of the glass adhesive comes in contact with the edge of the design element that you are sticking to your base glass. The liquid will run under the design piece adhering the two pieces together. (For this precise application the pink
'needle' tip is suggested). Allow about 15 minutes for the liquid to set, approximately 1/2 hour to dry. The slower setting time allows the artist to adjust their design if necessary.
SureStik™ can be used with all grades of frit and all design elements used in fusing. When adhering stringers, drop some liquid onto each end to ensure they don't roll when firing.(For this precise application the pink 'needle' tip is suggested).
SureStik™ can be mixed with powder or fine frit to make a paste for designing. It can also be mixed with larger frit for easier placement of the pieces ensuring they will not move. (For this precise application the larger opening in threaded cap is suggested).
A convenient way to mix the liquid with the frit: Pour a 'puddle' of liquid in the cap of the frit jar, add the frit and mix. The frit will be covered in liquid easily sticking to your glass. If there is any mixture left over you can let it dry in the cap to use next time. Just add some more adhesive and you're ready to go.
SureStik™ will completely burn off in the kiln leaving a clean surface to your glass. After applying, it allows the artist to move the design for about 15 minutes before starting to set. SureStik™is water soluble - change your mind? wash your design with water and start again or drop some more liquid to move your design around.
|
|